image
image

Aggregate Materials

Aggregate Materials

Our aggregates materials are state certified granular materials such as sand, gravel, or crushed stone that, with water and portland cement, are the essential in creating the right concrete strength for your project. Our goal is to manufacturer superior concrete mix using aggregates from our facility that is clean, hard, strong, particles free of absorbed chemicals or coatings of clay and other fine materials that could cause the deterioration of concrete.

Aggregates used in creating concrete can account up to 75 percent of the total volume used and these materials are divided into two distinct categories: fine and coarse sizes. Fine aggregates generally consist of natural sand or crushed stone with particles sizes of 3/8-inch (9.5-mm). Coarse aggregates are generally in the range of 3/8 and 1.5 inches in diameter.

 

Gravels constitute the majority of coarse aggregate used in creating concrete with crushed stone. Again, our aggregates and gravel are certified state approved materials. Crushed aggregate is produced by crushing quarry rock, boulders, cobbles, or large-size gravel. Our concrete recycling center is also a viable source of aggregate. Our Aggregate processing consists of crushing, screening, and washing the aggregate to obtain proper cleanliness and gradation. 

Contact us about having concrete delivered or the pickup of asphalt or delivered or picked up from your job site.

 

RCA

image

Recycled Alternative to #57 Limestone and Approximately 1 to 1 1/2 inch diameter.

2NS

image

This is a coarse concrete sand that can be used for site mixed concrete. This material compacts well and will work as a paver base.

6AA L.S.

image

This material is used in driveways and landscape applications

A Natural

image

3/8 to 1 inch diameter material suitable for drain fields, drywells, and landscape projects

Pea Stone

image

This material is used for play areas and some drainage projects

Fill Sand

image

This material is an inexpensive, ungraded sand used for sub-grade and backfill

21A L.S.

image

This material is often specified for stabilization of an area.

Grey Sand

image

1/2 inch minus pipe bedding, paver and base or general backfill.

Crushed Asphalt

image

1 1/2 inch minus recycled asphalt. Good for trails or roadways with limited traffic.

21A C.C.

image

A lower cost alternative to 21AA limestone

Oversized C.C.

image

2 to 6 inch large sized product used for stabilizaion of a run off area or as a base material.

Mason Sand

image

Used in mortor for brick and block. Great for above ground pool bases and sand boxes